A single cycle appears on the screen when _______
1. sweep and signal frequencies are equal
2.sweep and signal frequencies are not equal
3.sweep and signal frequencies are zero
4.sweep frequency is greater than signal frequency
Posted Date:-2022-05-06 06:25:12
C.R.O gives _______
1.actual representation
2.visual representation
3.approximate representation
4. incorrect representation
Posted Date:-2022-05-06 06:13:27
Deflection system of a CRT consists of _____
1.4 plates
2. 6 plates
3.2 plates
4.8 plates
Posted Date:-2022-05-06 06:22:03
Electron beam diverges.
1.True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:20:56
Electron beam is deflected in _______
1. 1 direction
2. 4 directions
3. 3 directions
4.2 directions
Posted Date:-2022-05-06 06:16:38
Focusing and accelerating anodes are ____
1. rectangular
2. cylindrical
3.spherical
4. square
Posted Date:-2022-05-06 06:21:37
Lumped parameter delay line consists of______
1.RC networks
2. RL networks
3.LC networks
4.Resistive networks
Posted Date:-2022-05-06 06:34:27
Phase inverter is used in an amplifier in the CRO because ____
1. phase inversion is needed
2.no phase inversion is needed
3.it is needed to operate a push pull
4. it provides voltage stability
Posted Date:-2022-05-06 06:31:36
Role of an attenuator is ________
1. to boost the signal
2.to distort the signal
3. to remove noise
4. to improve the operation
Posted Date:-2022-05-06 06:30:11
Spot is displayed only when _______
1. frequencies are different
2.frequencies are zero
3. frequencies are same
4.voltage is high
Posted Date:-2022-05-06 06:24:25
Vertical deflection is given by ________
1.y = Ky Vy
2.y = Ky
3. x = 1
4.y = Vy
Posted Date:-2022-05-06 06:22:56
What is done to make the trace horizontal?
1.negative voltage is applied
2.positive voltage is applied
3.no voltage is applied
4.voltage is synchronised
Posted Date:-2022-05-06 06:24:49
What is the effect of the signal delay on the sweep generator?
1. no effect
2.input increases in magnitude
3. output doesn’t get any delay
4.output gets sufficient delay
Posted Date:-2022-05-06 06:36:16
What is the flyback period?
1.voltage is very high
2.current is very low
3.voltage is zero
4.current is very high
Posted Date:-2022-05-06 06:25:36
What is the role of an invert in a CRO?
1. inverts the output
2.inverts the input
3. attenuates the input
4.magnifies the input
Posted Date:-2022-05-06 06:39:32
A circuit tuned to a frequency of 1.5 MHz and having an effective capacitance of 150 pF. In this circuit, the current falls to 70.7 % of its resonant value. The deviates from the resonant frequency are 5 kHz. Effective resistance of the circuit is?
1.2 Ω
2.3 Ω
3. 5.5 Ω
4.4.7 Ω
Posted Date:-2022-05-06 06:06:27
A circuit tuned to a frequency of 1.5 MHz and having an effective capacitance of 150 pF. In this circuit, the current falls to 70.7 % of its resonant value. The frequency deviates from the resonant frequency by 5 kHz. Q factor is?
1.50
2.100
3.150
4.200
Posted Date:-2022-05-06 06:06:02
Alternate is used to shift the inputs.
1.True
2. False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:42:13
Amplifier is multiple stage in a CRO.
1. True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:30:35
Amplifier stage is ______
1.half band
2. full band
3.wide band
4.narrow band
Posted Date:-2022-05-06 06:29:39
BJT is used in the amplifier stage.
1.True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:31:59
Control grid is given _______
1.positive voltage
2.negative voltage
3.negative voltage
4.zero voltage
Posted Date:-2022-05-06 06:19:46
CRO can’t display microseconds time.
1. True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:17:25
CRO is a ______
1.fast x-y plotter
2. slow x-y plotter
3.medium x-y plotter
4.not a plotter
Posted Date:-2022-05-06 06:17:07
CRO stands for _____
1. Cathode Ray Oscilloscope
2.Current Resistance Oscillator
3.Central Resistance Oscillator
4.Capacitance Resistance Oscilloscope
Posted Date:-2022-05-06 06:12:14
CRO uses ______
1.2 delay lines
2.3 delay lines
3.4 delay lines
4.5 delay lines
Posted Date:-2022-05-06 06:33:38
Delay for the T section is given by ____
1. ts = 1⁄fc
2. ts = 1
3.ts = 1⁄π
4. ts = 1⁄πfc
Posted Date:-2022-05-06 06:34:52
Distributed parameter delay line is a transmission line.
1.True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:35:11
During trace time, voltage is decreasing with time.
1.True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:26:12
Effect of negative voltage to the grid is ______
1. no force
2.a gravitational force
3. an attractive force
4.a repulsive force
Posted Date:-2022-05-06 06:20:39
Electron gun section _____
1. provides sharp beam
2.provides poorly focussed beam
3.doesn’t provide any beam
4.provides electrons only
Posted Date:-2022-05-06 06:18:52
Front panel of a CRO has ______
1.4 sections
2.8 sections
3. 15 sections
4.20 sections
Posted Date:-2022-05-06 06:37:43
Horizontal deflection is given by ____
1. x = Kx
2. x = Vx
3.x = 1
4. x = Kx Vx
Posted Date:-2022-05-06 06:22:26
Inductance does not affect a transmission line.
1.True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:35:25
Input signals are amplified using _______
1. rectifier
2.amplifier
3.oscillator
4.op amp
Posted Date:-2022-05-06 06:29:18
Input stage in the amplifier consists of _____
1. oscillator
2.attenuator
3.rectifier
4.op amp
Posted Date:-2022-05-06 06:31:12
Light produced in a screen is ____
1. disappears immediately
2.does not disappear at all
3.is not visible to the eye
4.disappears slowly
Posted Date:-2022-05-06 06:26:45
Oscilloscope is _______
1. a ohmmeter
2.an ammeter
3.a voltmeter
4.a multimeter
Posted Date:-2022-05-06 06:16:05
Position knob in a CRO indicates _____
1. voltage position only
2.time position only
3. current position only
4. any pattern’s position
Posted Date:-2022-05-06 06:41:58
Q Meter is used to measure ____
1.Q factor of an inductive coil
2.Only the effective resistance
3.Only bandwidth
4.Q factor of an inductive coil, the effective resistance, and bandwidth
Posted Date:-2022-05-06 06:06:55
Q meter operator is the principle of _______
1.Series resonance
2.Current resonance
3.Self-inductance
4.Eddy currents
Posted Date:-2022-05-06 06:05:36
Sinusoidal voltage is not observed on the screen.
1.True
2.False
3.all of the above
4.None of the mentioned
Posted Date:-2022-05-06 06:25:52
T section in a delay circuit of CRO acts as ____
1.high pass filter
2.low pass filter
3.band pass filter
4. band reject filter
Posted Date:-2022-05-06 06:34:06
Typical values for a distributed parameter delay line are ________
1.Zo = 10 Mῼ and td = 10 nsec/m
2.Zo = 1 kῼ and td = 500 nsec/m
3.Zo = 1000 ῼ and td = 180 nsec/m
4.Zo = 100 Gῼ and td = 275 nsec/m
Posted Date:-2022-05-06 06:35:48
Typically oscilloscope represents ______
1.current and time
2.resistance and time
3.voltage and time
4.power and time
Posted Date:-2022-05-06 06:17:52
Visible spot must be moved in _______
1. two directions
2.one direction
3.three directions
4.four directions
Posted Date:-2022-05-06 06:24:06
What determines light intensity in a CRT?
1.voltage
2.current
3.momentum of electrons
4.fluorescent screen
Posted Date:-2022-05-06 06:20:10
What is the role of astigmatism in a CRO?
1.increases the intensity
2. used for voltage stability
3.diminishes the intensity
4. focus control
Posted Date:-2022-05-06 06:38:47
What is the role of CRT?
1. to emit electrons
2.to emit protons
3.to emit neutrons
4.to emit alpha particles
Posted Date:-2022-05-06 06:28:33
What is the role of scale illumination in a CRO?
1.measurement
2. illumination
3.sharpness
4.stability
Posted Date:-2022-05-06 06:39:08
What is the role of the focus section in a CRO?
1. increases the focus
2.decreases the focus
3.controls sharpness
4.maintains the focus zero
Posted Date:-2022-05-06 06:38:26
What is the role of the intensity section in a CRO?
1.decreases the light intensity
2.controls light intensity
3.increases the light intensity
4.keeps the light intensity zero
Posted Date:-2022-05-06 06:38:05
What provides a periodic voltage waveform?
1.sweep generator
2.voltmeter
3.oscillator
4.amplifier
Posted Date:-2022-05-06 06:23:45
Why is a delay line used in a CRO?
1. to boost the signal
2.to distort the signal
3.to provide signal delay
4.for stability
Posted Date:-2022-05-06 06:32:18
X10 in a CRO means ________
1.one tenth
2.control knob
3.10 times as normal
4.attenuate the voltage by 10 times
Posted Date:-2022-05-06 06:41:35